ساخت فرایند برای کربن فیبر مربع لوله شامل تقریبا 5 مراحل٪ 3a
قالب ساخت
٪c2٪a0 ٪c2٪a0 According to the the customer٪27s requirements of the square tube size of the mold design٪2c including the molding of the the tooling requirements٪2c but also take into account a series of conditions of the carbon fiber square tubes size٪2c according to the need to determine the thickness of the the reserved tolerance tube.
٪c2٪a0 ٪c2٪a0 in order to ensure dimensional accuracy٪2c but also pay attention to the bending deformation٪2c if the pipe size is larger٪2c you need to use high-strength steel mold.
Prepreg برش
٪c2٪a0 ٪c2٪a0 After the mold is designed٪2c the carbon fiber prepreg needs to cut according to the size٪2c the unidirectional carbon fiber prepreg needs to be stack at ٪7b٪7b0٪7d٪7d degree and 90 degree٪2c and the way of laying needs to be determined according to the stress situation of the carbon fiber products.
٪c2٪a0 ٪c2٪a0 After prepreg and mold are completed٪2c the prepreg should be filled.
٪c2٪a0 ٪c2٪a0 Spread the carbon fiber prepreg layer by layer on the mold٪2c compact the prepreg to ensure that the the resin flows inside after closing the mold.
٪c2٪a0 ٪c2٪a0 the tighter the carbon fiber product is inside٪2c the better the the finished product will perform.
٪c2٪a0 ٪c2٪a0 When installing the mold٪2c it is also necessary to apply a release agent to facilitate the release of the the mold.
گرمایش پخت
٪ c2٪ a0 ٪ c2٪ a0 پس از قالب تکمیل شده است ٪ 2c کربن فیبر شمش قرار داده شده در گرما فشار برای کامل پخت از کربن فیبر مربع لوله تحت دما و فشار.
٪c2٪a0 ٪c2٪a0 During the manufacturing process٪2c it is necessary to pay attention to the changes of molding temperature and time parameters.
٪c2٪a0 ٪c2٪a0 the manufacturing of carbon fiber square tubes is closely related to temperature٪2c pressure and time.
٪ c2٪ a0 ٪ c2٪ a0 بعد از قالب تکمیل شده است ٪ 2c فشار و عایق همچنین نگهداری می شود.
دمولدینگ تکمیل شد
٪c2٪a0 ٪c2٪a0 Carbon fiber square tubes are taken out by the demolding equipment٪2c and after the demolding is completed٪2c they are taken out and put into the molding machine.
٪c2٪a0 ٪c2٪a0 After the demolding is completed٪2c the mold needs to cleaned before repeating the above steps.













